Technical Data - Lowara ResiBoost MMW Manuel D'installation Et D'entretien

Example: ResiBoost MMW09DE
DE
...

3.3 Technical data

Table 11: MMW and MTW standard versions
Converter mod- MMW09...
el
Rated voltage 1x230V (-20% – +10%)
input (Uin)
Rated voltage 1x(0–100%)Uin 3x(0–100%)Uin
output (Uout)
Rated input fre-
quency
Output frequen-
cy
Rated input cur- 9,5A
rent
(Uin-230V)
Rated output
8
current
(Uout=230V)
Overcurrent 20%, 10 second maximum
Recommended 13A
9
line protection
Consumption in
standby
Type of load
Nominal cosφ ≥ 0,60
(motor)
IP protection
Maximum pow-
er cable section
Maximum motor
power cable
section
8
The current supplied by the converter shall not be lower than current absorbed by the electric pump and cable, if this is
very long.
9
Choose the current of the line protection device in relation to the maximum current absorbed by the motor. The value in
the table refers to the full load condition.
10
For higher altitudes or other environmental conditions not covered in this manual, contact service.
Available in the following
sizes, depending on type
(refer to the technical da-
ta): 06A, 09A, 10A, 12A.
Type of plug of converter
power supply cable
DE: European Schüko
UK: British
AU: Australian
C: without plug
EMC class = C1 (EN
61800-3) ≈ B (EN 55011)
(A1) = C2 (EN 61800-3)
≈ A1 (EN 55011)
MTW10...
50/60±2 Hz
15–70 Hz
18A
9A 10A
25A
4W
electric motor
≥ 0,75
55
2
2,5 mm
2
2,5 mm
Set-point pres- 0,5–8 bar (50–800 kPa)
sure
Maximum pres-
sure (PN)
Water flow rate
Ambient tem-
perature
Maximum water
temperature
Ambient humidi- < 50%, non-condensing
ty
Pumped liquid Water that is free of aggressive
chemical substances and sus-
pended solids. Not suitable for
10
Elevation
Protection fuse 16A
(inside)
Digital input for
float switch con-
tact
Dimensions and See
weight
Table 12: MMA and MTA standard versions
Converter mod- MMA
el
06...
Rated voltage 1x230V (-20% – +10%)
input (Uin)
Rated voltage 1x(0–100%)Uin 3x(0–100%)Uin
output (Uout)
Rated input fre-
quency
Output frequen-
cy
Rated input cur- 6,3A
rent
(Uin-230V)
Rated output 6A
8
current
(Uout=230V)
Overcurrent 20%, 10 second maximum
Recommended 13A
9
line protection
Consumption in
standby
Type of load
en - Original instructions
15 bar (1500 kPa)
0,5–250 l/min
0–50°C (32–122°F)
40°C (104°F)
contact with glycol.
≤2000m asl
20A
24Vdc, 23,9mA
Figure 3 on page 270.
MMA MTA MTA
12... 06... 10...
50/60±2 Hz
15–70 Hz
12,6A 11A 18A
12A 6A 10A
16A 16A 25A
4W
electric motor
27