Using On Slopes; Start-Up - Stiga R72 Li 48 V1 Manuel D'utilisation

Status
Emergency button activated.
Cutting means engaged.
Cutting means engaged.
Machine ON and Operating.
Machine ON and Operating.
DANGER
If any results do not to match the indications
in the tables, do not use the machine!
Contact an Authorised Service Centre to
have it checked and repaired if necessary.
NOTE
Always bear in mind that the safety devices
prevent the machine from starting if safety
requirements have not been met. In such cases,
once start-up consent has been reset, remove
the key before starting the machine again.

7.3 USING ON SLOPES

Comply with the limits indicated in the
"Technical Data" Tables as in "fig. 12"
regardless of the mowing direction.
Remember there is no such thing as a "safe"
slope. Driving on grass slopes requires
particular care. To prevent overturning
or loss of control over the machine:
• Never mow across the face of the slope.
Lawns on slopes must be mowed by moving
up and down and never across them in
forward gear. When changing direction,
take great care that the wheels facing the
slope do not hit any obstacles (such as
stones, branches, roots, etc.) that may
cause the machine to slide sideways,
tip over or make you lose control.
Action
Attempt to start the machine.
Reverse is activated without
holding down the reverse
mowing consent button.
Lift the grass catcher or remove
the rear discharge guard (for
rear collection models only)
Release the drive pedal.
Test drive.
• Do not stop or start suddenly
• Shift to drive gear very gently paying
• Reduce speed:
• Never switch to reverse gear to decrease
Reduce forward speed if the
machine is moving on a slope.
7.4
To start the machine:
1. Check that the transmission
2. Sit in the operator's position.
3. Fully insert the key (fig. 6.A).
4. Wait for the machine's electrical check
5. Press the power button (Fig. 7.A).
6. Wait until the "Ready" icon
EN - 17
The machine switches ON. The
icon in fig. 7.E flashes and the
icon in fig. 7.O is illuminated.
Drive and cutting means do not work.
The cutting means disengage.
The cutting means disengage.
The machine slows down and stops.
No unusual vibrations, no unusual
sound, correct operation of the
steering, controls and pedals.
when going up or downhill;
particular attention to prevent the
machine from tipping up.
• before changing direction
and during tight turns
• before tackling a slope, especially downhill,
to ensure a safe braking distance.
speed when going downhill: this could
cause loss of control of the machine,
especially on slippery ground.
NOTICE

START-UP

is engaged (par. 6.3).
to be performed, during which the icons
on the pushbutton panel will flash.
(fig. 7.K) is ON steady.
Result