Stiga R72 Li 48 V1 Manuel D'utilisation page 116

8. The icon in fig. 7.E remains ON
and battery LEDs 1, 4 and 5 flash.
9. The icons in fig. 7.E and
fig. 7.O remain ON, battery
LEDs 1 and 3 flash.
10. The icon in fig. 7.E remains ON
and battery LEDs 1, 3 and 5 flash.
11. The icons in fig. 7.E and
fig. 7.O remain ON, battery
LEDs 1, 2 and 4 flash.
12. The icons in fig. 7.E and fig. 7.O
remain ON, battery LEDs 1, 2, 4
and 5 flash.
13. The icons in fig. 7.E and
fig. 7.O remain ON, battery
LEDs 1, 2, 3 and 5 flash.
14. The icon in fig. 7.E remains
ON and battery LED 2 flashes.
Current overload to cutting
means caused by:
1. Work conditions too demanding.
2. Obstructions that prevent
rotation of the cutting means.
3. The cutting means
assembly is full of grass
Cutting means motor over-
temperature caused by:
Work conditions too demanding.
Cutting means motor stall caused by:
1. Work conditions too demanding.
2. Obstructions that prevent
rotation of the cutting means.
3. The cutting means
assembly is full of grass
Drive motor over-
temperature caused by.
1. Drive motor under stress.
2. Slope too steep .
3. Excessive mud on the wheels.
The machine starts with the
drive pedal not released
(not in neutral position).
Drive engagement/disengagement
lever in drive disengaged position.
Battery detection/
communication error
EN - 28
Reduce forward speed:
Increase the cutting height:
Remove the obstructions.
Clean the cutting means assembly:
Turn off the machine, wait for at
least 5 minutes and then restart it.
Reduce forward speed:
Increase the cutting height:
Reduce forward speed:
Increase the cutting height:
Remove the obstructions.
Clean the cutting means assembly:
Switch off the machine and wait
for at least 5 minutes before
repeating the starting procedure.
Reduce forward speed:
Reduce speed and check the slope
of the ground where you are working.
Make sure that the wheels are not
blocked and clean as needed.
Switch off the machine and
repeat the starting procedure
only after having checked that
the drive pedal is in the neutral
position (pedal released).
Check the position of the drive
engagement/disengagement
lever and, if necessary, return it
to the drive engaged position.
If the problem persists,
contact a Service Centre.
Switch off the machine and
repeat the starting procedure
Check the correct mounting/
installation of the batteries
in their respective slots.
If the problem persists,
contact a Service Centre.