Installation; Positioning; Electrical Connection - ETNA EKP358RVS Mode D'emploi

INSTALLATION

Positioning

Electrical connection

EN 12
• Place the hob on a firm, flat surface.
• Keep a minimum space of 5 cm around the hob.
• Wall socket and plug must be accessible at all times.
• Do not place any inflammable or deformable objects immediately
under the hob.
• Put the plug in a socket.
• Make sure that the connecting cable does not come into contact
with parts that become hot.
IMPORTANT
The appliance is connected according to the connection scheme
2L-2N, 230VAC.
If a different connection is needed, the appliance should only be
connected by a qualified fitter. Improper connection can cause the
hotplates to burn out. This is not covered by the guarantee.
If the connection cable is damaged, it should be replaced by a qualified
service engineer or by the Etna service department.
L L N N
1 2 3 4
2L-2N 230V ~
L L N
1 2
1 2 3 4
2~-1N 230V ~
L N
1 2 3 4
L - N 230V ~