Kessel Aqualift S Compact Notice D'utilisation D'origine page 49

Adapting/fitting upper section
▶ Check the remaining difference in height between the top edge of the floor-
ing and the tank once again. Take the height of any planned floor covering
into account. When screed is laid, care must be taken to slope the screed in
the direction of the drain.
▶ Shorten the upper section such that the height difference determined + the
minimum covering (47 mm) is assured.
▶ The contour line on the upper section indicates the maximum shortening. If
maximum shortening is exceeded or minimum overlap is not observed, the
leak-tightness of the tank is not guaranteed.
▶ Fit and align the upper section (note contact points). Up to 5° angle of
inclination is permissible.
016-059 Installation and operating manual
Fig. [15]
max. 5°
Fig. [16]
49