Arjohuntleigh Enterprise 5000X Notice D'utilisation page 17

WARNING
If the power cord or mains plug is damaged, the complete
assembly must be replaced by authorised service personnel. Do
not remove the fitted plug, or use a rewireable plug or adapter.
Make sure the power supply cord is not stretched, kinked or
crushed.
Do not allow the power supply cord to trail on the floor where it
may cause a trip hazard.
Make sure the power supply cord does not become entangled
with moving parts of the bed.
Disconnect the power supply cord from the electricity supply,
and store it as shown, before moving the bed.
Caution
Before the first use, or if the bed has been unused for more than
three months, connect the bed to the electricity supply for at
least 24 hours to allow the backup battery to recharge fully.
Failure to do this may reduce the life of the battery.
The bed should be positioned with the roller buffers at least
20cm from the rear wall to prevent the head board striking the
wall when the bed is in head down tilt (Trendelenburg).
15