Troubleshooting - Compex FIT 5.0 Mode D'emploi

EN
5 . T RO UB L E SHOO TI NG
ELECTRODE FAULT
The remote control displays the symbol of an electrode and a disconnected module and an arrow flashes on
the channel in question (in this case, channel 1).
• Ensure that the electrodes are properly connected to the module.
• Check to see if electrodes are old, worn and/or if contact is poor: try using new electrodes.
MODULE OUT OF RANGE
The remote control displays the out of range symbol and an arrow flashing on the channel where the problem
was detected (in this case, channel 1).
• Check to make sure that the module and the remote control are less than 2 metres away from each other.
• Make sure you are not in an isolated area with no obstacle to reflect the signal from the remote control.
• Make sure you are in an area that enables the signal to be reflected from the remote control.
29