Troubleshooting - Compex Edge Mode D'emploi

ELECTRODE FAULT
The Compex Edge "bleeps" and alternatively displays the symbol of a pair of
electrodes and an arrow pointing to the channel where a problem has been
detected. In the example above, the stimulator has detected an error in channel 1.
• Check that electrodes are connected to this channel.
• Check whether the electrodes are old, worn, and/or the contact is poor: try using
new electrodes.
• Try using the stimulation cable on a different channel. If the cable is still showing a
fault, replace it.
STIMULATION NOT PRODUCING USUAL SENSATION
Check that all the settings are correct and ensure the electrodes are positioned
properly.
• Change the positioning of the electrodes slightly.
STIMULATION EFFECT CAUSES DISCOMFORT
The electrodes are beginning to lose adhesion and no longer provide good contact
on the skin.
• The electrodes are worn and need to be replaced.
• Change the positioning of the electrodes slightly.

TROUBLESHOOTING

Electrode Fault
38
Symbol