Selva Narwhal 115 Manuel D'entretien page 610

– +
ELEC
8190
IGNITION SYSTEM
B/R
B/W
MEASURING THE IGNITION SYSTEM
PEAK VOLTAGE
WARNING
When checking the peak voltage do not
touch any of the connections of the digital
tester lead wires.
NOTE:
• If there is no spark or the spark is weak,
continue with the ignition system test.
• If a good spark is obtained, the problem is
not with the ignition system, but possibly
with the spark plug(s) or another compo-
nent.
1. Measure:
NOTE:
• The peak voltage adaptor should be used
with the digital circuit tester.
• When measuring the peak voltage, set the
selector to the DC voltage mode.
Peak voltage adaptor
YU-39991 / 90890-03169
• ECM unit output peak voltage
Below specification → Check the wire
harness.
Correct the wire harness → Replace
the ECM unit.
ECM unit output peak voltage
Black/red (B/R) – Ground
Black/white (B/W) – Ground
Circuit
r/min
Cranking
V 5.0
Test harness (2-pin)
90890-06792
8-13
Loaded
1,500 3,500
122 242 245
E
8