Kreg Adaptive cutting system Guide D'utilisation page 30

Assembly
(1) Install three black hex head bolts, knobs,
and square nuts in the guide. Tighten the
assemblies to draw the bolt heads into the
knobs and then loosen them ½-1 turn.
Calibration
(1) Position two Versa-Stops in a
45° diagonal row of holes.
(2) With the adjustable fence facing the
infeed end of the table, slide the two
base-anchoring square nuts into a
table-track T-slot until the fence contacts
both Versa-Stops.
(3) Hold the guide in place and tighten all
three knobs.
(4) Loosen the pointer screw using a
Phillips screwdriver.
(5) Align the pointer with the 45° mark on
the angle scale. Firmly hold the pointer in
position of alignment and retighten the screw.
MITER GUIDE
2
3
1
1
1
1
1
3
3
4
5