Kreg Adaptive cutting system Guide D'utilisation page 13

Folding Base-Continued
(7) Position the wheel assembly with the
axle supports straddling the leg-assembly
upper bar.
(8) Fasten the wheel assembly to the table
top with U-bolts and small flange lock
nuts. Tighten the nuts using the included
wrenches or a 10mm deep socket and
ratchet wrench.
(9) Deploy the kickstand, engaging the
kickstand lock with the axle-brace flange.
(10) Thread foot levelers into leg assembly 2
(the one with handles).
(11) Position leg assembly 2 flat on the table top.
(12) Fasten the upper bar of the assembly
to the table top with U-bolts, bar brackets,
and small flange lock nuts. Tighten the
nuts using the included wrenches or a
10mm deep socket and ratchet wrench.
ASSEMBLY
12
12
8
8
7
8
8
11
10
10
9