Kreg Adaptive cutting system Guide D'utilisation page 19

(8) Turn the track right side up and orient it
with the anti-chip strip toward the near
edge of the table.
(9) Attach the outfeed-end hinge upright to
the outfeed-end hinge mounting plate
with the star knob and brass flat washer.
(10) Raise the hinge upright to the full-up
position and tighten the star knob.
(11) Install a cap screw and T-slot nut on the
second hinge and slide the nut into the
track infeed-end T-slot. Do not tighten
the screw.
(12) Attach the hinge upright to the
infeed-end mounting plate with the
star-knob and brass flat washer.
(13) Raise the hinge to the full-up position,
and tighten the star knob.
(14) Lift the track as you shift it toward the
infeed end to fully open both hinges.
(15) Tighten the hinge cap screw with the
included hex wrench.
ATTENTION:
Make sure both hinges are fully open prior to
tightening the hinge cap screw. This will ensure proper hinge operation.
GUIDE TRACK
13
14
10
9
11
11
12
15
8
12