Kreg Adaptive cutting system Guide D'utilisation page 18

ATTENTION:
The 62" guide track (Item # ACS430) is supplied
with the Plunge Saw + Guide Track (item# ACS2000), the Master Kit
(item# ACS3000) or is available separately.
ATTENTION:
Before mounting the guide track on the table,
trim the anti-chip strip, following the instructions included in the manual
provided with the Kreg Plunge Saw (item# ACS-SAW).
(1) With the table set up (see Table Setup),
install the star-knob, brass flat washer,
and Zinc hex-head bolt and T-knobs
and bolts on the hinge-mounting plates.
(2) Slide the heads of the T-knob bolts into
the T-slot in the table perimeter track.
(3) Position the plate-alignment tabs all the
way to the rear of the table-top notches.
(4) Tighten the T-knobs.
(5) Position the guide track upside down on
the table with the anti-chip strip toward
the center of the table.
(6) Install a cap screw and T-slot nut on the
first hinge and slide the T-slot nut into the
track outfeed-end T-slot.
ATTENTION:
Both hinges are identical and are installed so they
operate in the same direction to raise and lower the guide track.
(7) Position the edge of the hinge 2
from the end of the track, square it to the
track edge, and tighten the cap screw with
the included hex wrench.
GUIDE TRACK
⁄ " [64mm]
1
2
2
1
1
4
Anti-chip strip
1
1
1
1
3
4
5
6
7
2 ⁄ "
1
2