Kreg Adaptive cutting system Guide D'utilisation page 22

7
5
(4) Slide a tape rule under the guide track,
hook it on the inside edge of the
saw-blade kerf, and extend the tape past
the 10" mark.
(5) Slide a primary ruler, 8"-mark end first,
into the channel nearest the infeed end
(handle end) of the table in one table
track. Push the leading end of the ruler
into the ruler lock.
(6) Adjust the primary ruler 10" mark to align
with the 10" mark on the tape rule.
(7) Slide a secondary ruler, 0"-end first, into
the second channel in the track, engaging
the end in the ruler lock.
(8) Align the 0" mark on the secondary
ruler with the 10" mark on the
primary ruler.
Repeat these steps to install the
remaining rulers in the other table track.
TABLE-TRACK RULERS
GUIDE TRACK NOT SHOWN FOR CLAIRTY
4
6
8
ATTENTION:
The primary rulers must be in the infeed end (handle-end) slots in each table track.
ATTENTION:
Be sure to calibrate the rulers in both table tracks.
7
5