Kreg Adaptive cutting system Guide D'utilisation page 29

(3) Rotate the cam handle to one side.
(4) Slide the extension bar into the T-slot.
(5) Align the desired dimension on the
48" Extension Stop bar with the 48"
Extension Stop mark on the table-track
secondary ruler.
(6) Rotate the cam handle to lock the stop
in place.
ATTENTION:
Only rotate the cam handle enough to lock the bar. It
does not have to be in the vertical position.
(7) Install two Versa Stops on the outfeed edge
of the workpiece to keep it from shifting and
make the cut.
ATTENTION:
When positioning a workpiece, always push it
against the Versa-Stops first and then slide it sideways until it touches
the 48" Extension. The Versa-Stops withstand substantial pressure, the
extension does not.
48" EXTENSION STOP
4
3
Workpiece under
guide track
7
7
5