Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
(1) Remove the T-Knob located on the cut
side of the table.
(2) Insert the Hinge Support Bracket on the
Zinc Hex Head Bolt.
(3) Reinstall the T-Knob and tighten.
(4) Repeat the process for the opposing
Hinge Mounting Plate.
ATTENTION:
Both Hinge Support Brackets should be installed on
the cut end of the table on each Hinge-Mounting Plate.
HINGE SUPPORT BRACKET INSTALLATION
2
1
3
Publicité
Table des Matières
