Kreg Adaptive cutting system Guide D'utilisation page 23

Adjusting the guide track
for workpiece thickness
(1) Lift the guide track as you shift it toward
the outfeed end to fully close the hinges.
(2) Loosen both mounting-plate star-knobs
and lower the track onto the table. Leave
the knobs loose.
(3) Place the workpiece under the
guide track.
(4) For workpieces ½" and thicker,
raise the hinge upright at one end to fully
close the hinge.
(5) Lower the hinge upright
slightly open the hinge.
(6) Tighten the star-knob. Repeat at the
other end.
ATTENTION:
Slightly lowering the hinge uprights ensures that
the guide track rests on the workpiece allowing full contact between the
anti-slip strips and the workpiece.
USING THE PROJECT TABLE
⁄ - ⁄ " to
1 1
8 4
2
4
6
5
1
3
Hinge closed
Hinge slightly open