Kreg Adaptive cutting system Guide D'utilisation page 25

(1) Install black hex head bolt, knob,
and square nuts in the Repetitive Stops.
Tighten the assemblies to draw the bolt
heads into the knob, and then loosen
them ½-1 turn. Slide the square nuts into
the table-track T-slots.
(2) For cuts 8" to 25" wide, orient the stop with knob at the front and align the knob end of the stop with the
desired cut dimension on the primary ruler.
REPETITIVE STOPS
2
2
Waste piece
1
1
1
Workpiece