General Technical Data; Diameters Available - Burkert S030 Manuel D'utilisation

Paddle-wheel Body fitting material
material
PVDF • Stainless steel
• Brass
• PVDF
• PP
• PVC
Fluid pressure
P [bar]
A (T ype SE30 Ex
16
15
14
13
12
11
10
9
PVDF
8
PVC+PP
7
6
5
4
PVC
3
2
1
0
-30 -10 +10 +30
Fig. 1: Fluid pressure / temperature dependency curves
for fittings used on their own
English
12

General technical data

Max. Fluid viscosity 300 cSt
Type of fluid Clean, neutral or slightly aggressive
Rate of solid particles in max. 1 %
the fluid
Max. particle size 0,5 mm
Measurement range of the 0,3 to 10 m/s
flow rate in the pipe
≤ ±
Accuracy, with standard K
factor
2.5 % of the measured value)*
≤ ± 0,5 % of the full scale
Linearity
(10 m/s)*
± 0,4 % of the measured value*
Repeatability
* determined in the following reference conditions: medium =
water, water and ambient temperatures 20 °C, min. upstream and
downstream distances respected, appropriate pipe dimensions.

diameters available

The diameters available depend on the design of the S030
fitting.
Refer to the graph on page 32 to determine the
appropriate DN of the pipe and fitting.
English
14
Fluid temperature
-15 °C...+100 °C
+0 °C...+80 °C
+0 °C...+50 °C
)
Metal
PVDF
PP
+50 +70 +90 +110 T [°C]
Fluid temperature
(0.5 % of the full scale +
conformity to the pressure
directive
The S030 fitting complies with article 3 of §3 from 97/23/
CE directive.
Acc. to the 97/23/CE pressure directive, the device can
only be used in the following cases (depending on max.
pressure, pipe diameter and fluid):
type of fluid conditions
Fluid group 1 § 1.3.a only DN ≤ 25
Fluid group 2 § 1.3.a DN ≤ 32
or DN > 32 and PNxDN ≤ 1000
Fluid group 1 § 1.3.b PNxDN ≤ 2000
Fluid group 2 § 1.3.b DN ≤ 200
certificates available
• Certificate 3.1
• Certificate 2.2
• Roughness certificate
• Calibration certificate
• FDA approval (with EPDM seal), S030 in stainless steel
only
Design of the S030 fitting connections
Internal threads
External threads acc. to G, NPT or Rc, in
stainless steel or brass
External threads acc. to SMS 1145, in
stainless steel
Weld ends, in stainless steel
Clamp
Flanges
True-union
Spigot, in PVC, PP or PVDF
materials
Paddle-wheel Axis
Sensor holder
Body
Fig. 2: Sectional drawing of the S030 fitting
Component Material
Seal FKM
EPDM with FDA agreement on request
English
13 13
DN available
DN15 to DN50
DN06 to DN50
DN25 to DN50
DN08 to DN65
DN08 to DN65
DN15 to DN50
DN08 to DN50
DN15 to DN50
Seal
English
15 15