Description; Measuring Principle; General Information; Warranty Conditions - Burkert S030 Manuel D'utilisation

note
the fitting may be damaged by the fluid in contact
with.
• Systematically check the chemical compatibility of the
component materials of the fitting and the fluids likely
to come into contact with it (for example: alcohols,
strong or concentrated acids, aldehydes, alkaline
compounds, esters, aliphatic compounds, ketones,
halogenated aromatics or hydrocarbons, oxidants and
chlorinated agents).
English
8
5.

deScRipTion

Area of application
The S030 fitting is intended to measure the flow rate of clean
fluids in DN6 to DN65 pipes thanks to its paddle-wheel. It
must be combined with an electronic device (indicator, flow
threshold detector or transmitter) which converts the pulse
frequency due to paddle-wheel rotation.
The electronic device can be removed without opening the
piping or stopping the process.

measuring principle

The fluid flowing in the piping makes the paddle-wheel turn.
The paddle-wheel rotational frequency f is proportional to
the flow rate.
English
10
4.

GeneRAl infoRmATion

To contact the manufacturer of the device use following
address:
Bürkert SAS
Rue du Giessen
BP 21
F-67220 TRIEMBACH-AU-VAL
The addresses of our international branches can be found
on the Internet at: www.burkert.com

Warranty conditions

The condition governing the legal warranty is the conforming
use of the S030 in observance of the operating conditions
specified in this manual.

information on the internet

You can find the user manuals and technical data sheets
regarding the type S030 at:
6.

TechnicAl dATA

conditions of use
The fluid temperatures and pressures may be
restricted by the electronic device mounted on the
fitting: refer to the relevant manual.
Ambient temperature depends on the device mounted
on the S030. Refer to the relevant
manual.
Pressure class PN16 (or PN40 on request) for metal
fittings.
PN 10 for plastic fittings, depends on
fluid temperature, see Fig. 1.
Fluid temperature depends on the material from which
the S030 fitting and the paddle-wheel
are made, see the following table.
Paddle-wheel Body fitting material
material
PP • Stainless steel
• Brass
• PVDF
• PP
• PVC
www.burkert.com
English
Fluid temperature
+0 °C...+80 °C
+0 °C...+50 °C
English
9 9
11 11