Modifying The Steering Directions - Reely SKY EC 135 Notice D'emploi

j) Modifying the Steering Directions
Your remote control is tuned ex works exactly to your double
rotor electric powered helicopter.
However, if during trimming, you notice that your model
helicopter, with individual steering functions, responds
contrary to the pattern illustrated in figures 10 - 13, then you
can switch over at the transmitter, for each individual steering
function, the direction of the response of the model.
For this purpose, there are four reverse switches on the front
of the transmitter (also see figure 1, item 7).
The switches are assigned the following functions:
Switch Designation
1 RUD
2 THR
3 ELE
4 AIL
To switch over a steering function, first disconnect the flight battery in the helicopter, then switch off the transmitter and
push the corresponding reverse switch in the other switch position. Now you can start up the transmitter again, connect
the flight battery and check the correct function direction at the helicopter.
After switching the control direction, you may have to readjust the trim.
48
Function
Tail Function
Pitch Function
Nod Function
Roll function
Position
REV
NOR
REV
REV
Figure 17