Charging The Ir Adapter - Reely SKY I-Helicopter Notice D'emploi



7. Charging the IR Adapter

Connect the USB charging cable (1) to the IR adapter
according to the adjacent figure and connect the USB
charging cable to a free USB output of your computer/
notebook.
The red LED (2) at the IR adapter is lit during the charge
process.
When charging is completed, the LED in the charge adapter
goes out and the LED in the USB plug (3) is lit at full strength.
Disconnect the IR adapter from the USB charging cable after
charging.
The blue LED (see figure 2, item 4) serves and function display in flight operation. If the blue LED starts to
flash, cease flying immediately and charge the battery in the IR adapter.
Important!
Do not connect the charging cable to a USB hub without a separate mains adapter (e.g. a keyboard USB
port, etc.), because these will not provide sufficient current for charging.
The operating system does not recognize any new hardware after connection, because the USB port is
only used for power supply.
Please observe that the USB ports of your computer/notebook are usually only active when the computer/
notebook is switched on.
Therefore, switch on the computer/notebook before connecting the charging cable to the IR adapter and
the computer/notebook.
Figure 2
29