Basic Safety Instructions - Burkert PTB 07 ATEX 2048 Manuel D'utilisation

3.

BASIC SAFETY INSTRUCTIONS

These safety instructions do not make allowance for any
• contingencies and events which may arise during the installation,
operation and maintenance of the devices.
• local safety regulations, whereby the operator is responsible for their
compliance, by the installation personnel too.
Danger of explosion!
• The flipper valve is part of a closed system. During operation, it
must not be dismantled.
Danger – high pressure!
There is a serious risk of injury when reaching into the system.
• Before loosening the lines and valves, turn off the pressure and
vent the lines.
• During the installation, make certain the direction of flow is
correct.
• Observe applicable accident prevention and safety regulations
for pressurised devices.
• After an interruption in the power supply or pneumatic supply,
ensure that the process is restarted in a defined or controlled
manner.
Risk of burn due to hot device surface!
• Do not touch the device with bare hands.
6
English
07 ATEX 2048
Basic safety instructions
Danger of explosion caused by electrostatic charge!
If there is a sudden discharge from electrostatically charged devices
or persons, there is a danger of explosion in the EX area.
• Take appropriate measures to prevent electrostatic charges in the
EX area.
• Clean the device surface of the flipper valve by gently wiping it
with a damp cloth.
General hazardous situations.
To prevent injury, ensure that:
• the system cannot be activated unintentionally.
• no unauthorised changes are performed on the system.
• only expert and instructed personnel with appropriate tools carry
out any work on the system.
• you operate the flipper valve only when it is in perfect condition
and in consideration with the operating instructions.
• The general rules of technology apply to application planning
and operation of the flipper valve.