TROUBLESHOOTING GUIDE
Symptom
No heat, but light works.
No heat and no light.
OPTIONS AND ACCESSORIES
Flip-Up Doors
Flip-up doors are available for all models as an added option at
the time of order. Flip-up doors can be installed on each shelf
on either the customer side or operator side of the unit. Use
the following procedure to install flip-up doors (the procedure is
the same for either side as well as each shelf).
1. align the screw holes at each end of the flip-up door hinge
with the mounting hole in each end plate on the unit.
2. Insert a hinge screw through each end plate and into the
flip-up door.
3. Tighten the hinge screws until the flip-up door is secure.
Do not over-tighten the screws.
Mounting
Hole
Flip-Up Door Installation
Probable Cause
Unit/shelf in Off mode operation.
Temperature setpoints/power percentages
set too low.
Heating element(s) not working.
Sensors or LCD controller not working
properly.
Power turned OFF.
Circuit breaker tripped.
Hinge Screw
Hinge
Flip-Up Door
Change unit/shelf operation to auto mode or On
mode. Refer to the OPERaTION section for
procedure.
adjust temperature setpoints/power percentages to
higher settings. Refer to the OPERaTION section for
procedures.
Contact authorized Service agent or Hatco for
assistance.
Contact authorized Service agent or Hatco for
assistance.
move Power ON/OFF (I/O) switch to the ON (I)
position.
Reset circuit breaker. If circuit breaker continues to
trip, contact authorized Service agent or Hatco for
assistance.
Sneeze Guards
Sneeze guards are available for all models as an added option
at the time of order. Sneeze guards can be installed above each
shelf on the customer side of the unit.
Support Post Accent Lighting
Support post accent lighting is available for all models as an
added option at the time of order. The accent lighting consists
of a vertical strip of LED lights running up the center of each
support post.
Product Divider Rods
Stainless steel product divider rods are available as an
accessory.
HZM-DIV ................Stainless Steel Divider Rod
20
English
Corrective Action
Form No. HZmm-0414