Boston Scientific SC-2016 Série Mode D'emploi page 21

5. Place a small loop at the lead for slack. If necessary, loosely tie a suture around the lead-loop, but do
not tighten onto the lead.
CAUTION: Tightening sutures directly on the lead can damage the lead.
6. Carefully remove excess slack by gently pulling the extensions from the exit wound.
7. For Permanent Trials, if desired, a small suture may be used to close the exit wound of the extension.
Place and tape a stress relief loop and dress the wound. Proceed to the instructions for connecting to
the Trial Stimulator or OR Cable Connector, as follows:
SCS System
Precision SCS System
Precision SCS System with
MultiWave Technology
Precision Spectra SCS
System
Precision Novi SSC System
8. For permanent Implant, close the midline incision and proceed to instructions for connecting the IPG
as follows:
SCS System
Precision SCS System
Precision SCS System with
MultiWave Technology
Precision Spectra SCS
System
Precision Novi SCS System
Reference Document for instructions
Precision Spinal Cord Stimulator Clinician Manual
Precision Spinal Cord Stimulator System with
MultiWave Technology Clinician Manual
Precision Spectra System Clinician Trial Manual
Precision Spectra System Clinician Trial Manual
Reference Document for instructions
Precision Spinal Cord Stimulator Clinician Manual
Precision Spinal Cord Stimulator System with
MultiWave Technology Clinician Manual
Precision Spectra IPG DFU
Precision Novi IPG DFU
Instructions for Use
Section Title
"Connecting to the Trial Stimulator"
"Connecting to the Trial Stimulator"
"Inserting the Leads into the OR Cable
Connector"
"Inserting the Leads into the OR Cable
Connector"
Section Title
"Connecting to the IPG"
"Connecting to the IPG"
"Connecting the Lead, Extension, Splitter, or
Connector to the IPG"
"Connecting the Lead, Extension, Splitter, or
Connector to the IPG"
Percutaneous Leads Directions for Use
90970887-03 Rev A 17 of 441