Before Operating Snowthrower; Operate The Snowthrower; Operation - Murray 1695859 Manuel D'utilisation

BEFORE OPERATING SNOWTHROWER

Check the fasteners. Make sure all fasteners are tight.
On electric start models, the unit was shipped with the
starter cord plugged into the engine. Before operating,
unplug the starter cord from the engine.
SNOWTHROWER SAFETY TESTS
Test 1 - Auger/Impeller
• Release auger control (right-hand).
• Auger/impeller stops in less than 5 seconds.
Test 2 - Traction Drive
• Release traction control (left-hand).
• Snowthrower forward/reverse motion stops.
Test 3 - Free-Hand Control (if equipped)
• Engage auger control and traction control.
• Release auger control immediately followed by the traction
control (a) stops auger/impeller in less than 5 seconds, and (b)
stops forward/reverse motion of snowthrower.
DANGER: The discharge chute contains a rotating
impeller to throw snow. Never clear or unclog the
discharge chute with your hands. Fingers can quickly
become caught and traumatic amputation or severe
laceration will result. Always use a clean-out tool to
clear or unclog the discharge chute.
WARNING:
• Hand contact with the rotating impeller inside the
discharge chute is the most common cause of
injury associated with snowthrowers.
• This snowthrower is capable of amputating hands
and feet, and throwing objects. Read and observe
all the safety instructions in this manual. Failure to
do so will result in death or serious injury.
NOTE: This snowthrower was shipped WITH OIL in the
engine. See Check the Oil (Before Starting Engine)
instructions in this section before starting engine.

OPERATE THE SNOWTHROWER

CAUTION: Operation with a Snow Cab. Wind may blow
exhaust gasses back towards the operator. If you notice
the smell of exhaust, change direction of operation.
NOTICE: Do not throw snow toward a building as hidden
objects could be thrown with sufficient force to cause
damage.
1. Start the engine. Start the Engine in this section.
2. Turn the chute rotation crank (A, Figure 7) to set the direction
(left or right) of the discharge chute. See Discharge Chute
and Deflector in this section.
3. Loosen the wing nut (A, Figure 8) on the side of the discharge
chute to set angle (up or down) the snow is thrown. See Dis-
charge Chute and Deflector in this section.
CAUTION: Before operating, make sure the area in
front of the snowthrower is clear of bystanders or
obstacles.
4. Fully press and hold the auger control lever (B, Figure 7) to
engage the auger rotation. Releasing the auger control lever
will disengage the auger - unless the Free-Hand™ control is
activated.
5. Fully press and hold the traction/Free-Hand™ control lever
(C) to engage the traction drive and begin moving the snow
thrower. To disengage the traction drive, completely release
the lever.
6. When BOTH levers are pressed, the Free-Hand™ control is
activated. This allows you to release the auger control lever to
use the other controls. The auger will continue to rotate until
the traction/Free-Hand™ control lever is released.
NOTE: Always release the traction control lever before mov-
ing the speed select lever.

OPERATION

19