Sizing Guidelines - Volvo Penta QL Boat Trim System Instructions D'utilisation Et D'installation

300 mm
Fig. 4
450 mm
Cable (E) between Control Unit (A) and Control
Panel (B)
Each end of the cable is equipped with a 6-pole socket
plug.
Five lengts of the cable are available i.e:
* 5 m
* 7 m
* 9 m
* 11 m
* 13 m
Fig. 5
There is also a 6-pole Y-cable and a 6-pole extension
cable available, used when more than one helm station
is installed.
Cable (D) between Control Unit (A) and
Interceptor Unit (C)
Each end of the cable is equipped with 4-pole socket
plug and one of the ends also with an installation grom-
met.
Two lengts of the cable are available, i.e:
* 2.5 m
* 4 m
Fig. 6
For installation of the components, see chapter Installa-
tion of the QL Boat Trim System.
6
Plus d'informations sur : www.dbmoteurs.fr
Sizing guide lines
42 mm
Many factors affect the choice of properly sized trim unit
configurations, and the ultimate responsibility for selec-
tion is up to the boat owner/boat builder. These sizing
recommendations are based on average boat perfor-
mance. Your choice may vary based on power, engine
100 mm
configuration, weight distribution, type of boat and use.
When making a choice, please remember that the lar-
gest interceptor configuration that will comfortably fit on
the transom will be the most efficient. The QL Boat Trim
System is designed to fully replace conventional trim
tabs.
Boat length
15' - 24'
22' - 30'
28' - 34'
32' - 44'
42' - 50'
For semi-planing hulls, it may be necessary to increase
the length of the trim unit configuration.
Single engine Twin engine
installation installation
QL300
QL450 QL300
QL450 QL450
QL450 + QL300 QL450
QL450 x 2 QL450 x 2