Connecting The Ground Cable; Fitting The Console On The Handlebar - Elite RealAxiom Wireless Mode D'emploi

CONNECTING THE GROUND CABLE

To solve potential static issues that might cause sof-
tware disconnections during use, the ELITE RealA-
xiom Wireless includes a ground cable (Ref. Z) that
connects unit and frame (use is optional).
Installation is best carried out before mounting the
bicycle to the RealAxiom Wireless frame.
• Remove the nut-cover (Ref. DD) from the unit (Ref.
B) and unscrew the M4 nut (Ref. CC) (Fig. 29).
B
• Slide the hole at the end of ground cable over the
screw protruding from the unit (Ref. B) (Fig. 30),
replace the M4 nut (Ref. CC), tighten and replace
the nut cover (Ref. DD) (Fig. 31).
• Slide the ground cable (Ref. Z) under the rear tube of
the frame (Ref. A) (Fig. 32), unscrew the M4 screw (Ref.
EE) in the frame (Ref. A) (Fig. 33), then mount the end
of the ground cable (Ref. Z) to the frame with the M4
screw (Ref.A) (Fig. 34)
DD
29
30 FITTING THE CONSOLE ON THE
The console can be fitted in two different positions,
on the handlebar of the bicycle (see figure 35) or
on the handlebar stem (see figure 36).
31
Z
EE
HANDLEBAR
EN
32
33
34
35
31