Stand Assembly; Unit Installation; Fitting The Bicycle - Elite Novo Force Turbo Trainer Notice D'utilisation

EN
thank you for choosing the novo
Check the presence of all the following compo-
nents:
N°1 Novo frame (Ref. A)
N°1 Unit (Ref. B)
N°1 Unit support (Ref. C)
N°1 Quick release (Ref. D)
N°2 Plugs for wheels larger than 28" (Ref. E)
N°1 Screw (Ref. F)
N°2 Washer (G)
N°1 Nut (H)
N°1 Fixing lever (I)
Resistance unit depicted here may vary
from production models
stAnd AssemblY
• Open the stand and position it on a flat surface.
• Remove the screws (F+G+H) on the stand
(Fig.1).
• Take the unit support (C), press the two buttons
on the upper part of the support (Fig. 2) with fin-
gers, and fit it inside the two holes in the frame
(Fig.3 and Fig.4)
• Using the screw shown in Fig.1 (F+G+H), fit the
unit support (C) on the respective frame (Fig.5).
Use the correct tightening force, otherwise the
unit support will be prevented from turning.
8
IntroduCtIon
AttentIon
unIt InstAllAtIon
• There are two pairs of holes in the base of the
support; use the various holes according to the
bicycle wheel:
≥ ≤
1) for wheels 24" ÷
(Fig. 6);
≥
2) for wheels 28", rear pair of holes (Fig.7).
• Depending on the wheel, tighten the M6 screws
(Fig. 8 and Fig. 9).
• Use solely the included wrench to attach the
resistance unit to the frame base as shown in the
figure 10. Tighten ¼ of a turn after contact is
made between resistance unit and frame base
(apply max force 2 Nm).
• For bicycles with wheels larger than 28" it is
necessary to operates on the frame, changing the
plugs of the front uprights with the oversize plugs
provided (E). These differ for the stand opening
angle.
AttentIon: This operation must be carried out
with the unit removed from the support.
• Remove the screws from both front uprights
(Fig.11 and Fig.12).
• Remove the plug, using a screwdriver if neces-
sary Fig. 13.
• Insert it inside the seat specially created in the
plug and prise, pushing the screwdriver downward
and the plug upward.
• Repeat the same operation also for the other
plug.
• Fit the plugs for wheels larger than 28" (E),
using a rubber hammer if necessary (Fig. 14).
• Reposition the tubes with respective screws
(Fig. 11 and Fig. 12).
FIttIng tHe bICYCle
• Make sure the quick release of the bicycle rear
wheel is properly fixed.
• Turn the lever (F) to the "open" position (fig. 15).
26", front pair of holes