Fitting The Bicycle - Elite QUB0 Mode D'emploi

FITTING THE BICYCLE

• Make sure the quick release of the bicycle rear
wheel is properly fixed.
• Turn the lever (F) to the "open" position (Fig. 7).
F
• Put the bicycle in position, inserting the left end
of the rear quick release in the left bushing (Fig.
8). For safer clamping of the bicycle on the stand,
make sure the lever of the quick release is hori-
zontal (Fig. 9).
• Close the lever (F), making sure it starts pres-
sing the quick release inside the predefined work
area; between 55° and 65° (Fig. 10).
7
• If the lever (F) starts pressing the quick release
in the advanced work position (Fig. 11), screw the
left bushing pin (g) (Fig. 12) so that the lever (F)
starts working inside the predefined work area
(between 55° and 65°) (Fig. 10).
8
EN
parallel
9
10
11
13