Assembling The Unit; Using The Unit - Elite Digital Smart B+ Mode D'emploi

EN
• Attention: Integrated wireless systems that
work on the same frequency band can
interfere with the data transmission of Digital
Smart B+. In this case, deactivate them.
• Avoid exposure to direct sunlight or cold and
damp environments for prolonged periods of
time when not in use.
• Never use chemical detergents (petrol or
thinners) on any part of Elite Digital Smart B+.

ASSEMBLING THE UNIT

To fit the unit (ref. A) on the frame, follow the
instructions given in the Frame manual.
Plug the resistance unit (ref. B) into a wall
outlet and into the resistance unit, using the
supplied power cord.
Digital Smart B+ is ready for use after mounting
the unit to the frame. You will need a compati-
ble* app, computer and software to display
data and adjust resistance.
The pairing, data collection and resistance-
adjustment phases use the ANT+ and Bluetooth
Smart protocols, while the various modes will
depend on the app/cycle computer.
The connection procedure and the use of the
device depends on the device itself and the
software/app you wish to use. Check the
software/app for instructions on how to
connect and for use during training.
* Please check chart 1 page 11 to verify com-
patibility with your smartphone/tablet/cycle
computer.
12
NOTES

USING THE UNIT

ATTENTION
• During use of Digital Smart B+ with Elastogel
roller, slight wear of the roller is quite normal.
Tests carried out at Elite show that after conti-
nuous use for 20,000 km, roller wear is around
0.1 mm, and since the total thickness is 10
mm, correct operation of the trainer will not be
affected even with far greater wear. Claims
that are due to improper or careless use, will
not be acknowledged. Slight wear of the part in
rubber is quite normal.
• Using Digital Smart B+ with narrow tyres or
with unsuitable tyre pressures can permanen-
tly damage the Elastogel roller.
• Do not store Digital Smart B+ in wet or damp
places. The electronic components could
become damaged.
• Digital Smart B+ may not comply with the EC
directives if the power adapter supplied (ref. B)
is not used.
• If slipping of the wheel on the Elastogel roller
is noticed, apply a more gradual force on the
pedal. Training with the tyre slipping can per-
manently damage the Elastogel roller.
TROUBLESHOOTING
• The trainer doesn't change the resistance:
if you're having trouble connecting, try
removing all electronic devices (such as
Smartphones and/or wireless routers) or
changing the transmission channel ¹ and
repeat the pairing process with the app/
software/cycle computer again.
The cadence value is not accurate:
the algorithm that calculates cadence without
a sensor can sometimes vary in accuracy. This
might happen when training with a high peda-