Elite RealAxiom Wireless Mode D'emploi page 37

EN
• If the resistance unit is to remain inactive for a long
period of time, completely remove the unit from the
frame and place it in its original box.
In this case, the removal of the power supply cable
and cadence sensor and their storage with the
console and the USB key in an environment that
protects them from moisture is recommended.
Whenever the roller has to be shipped for assistance
or for some other reason, special attention must be
paid to ensure its correct packing.
• If it's connected, unplug the ground cable (Ref. Z)
between unit and frame.
• Remove the resistance unit from stand, undoing
the 2 screws fixing it to the support plate.
• Detach all the cables from the resistance unit (power
supply cable – ref. U; cadence sensor cable – ref. H)
• Keep people, children and animals away from the
roller during use, since the moving and rotating
parts of the roller and the bicycle can cause damage
in case of contact.
• Before starting training, position the trainer in a
dry place, away from potentially hazardous objects
(furniture, tables, chairs, etc.) in order to avoid any
risk of inadvertent or accidental contact with them.
• The resistance unit becomes warm when in use.
Wait until it has cooled before touching shells.
• Do not brake when using the trainer, as this can
permanently damage the roller and the tyre.
• The stand is designed for use by just one cyclist.
• Check the safety and stability of the bicycle before
every training session.
• If the quick release is not compatible with the bushings
of the stand, replace it with the one supplied (T).
• There are no individually usable components on
the inside. The warranty is invalidated if the unit
36
PACKING
ATTENTION
• Unplug all cables from the resistance unit – ref. U;
cadence sensor cable – ref. H; ground cable (ref. Z)
(if connected).
• Remove the USB key from the PC.
• Remove the cadence sensor from the bicycle frame.
• Put the cables, cadence sensor, power adapter,
console and USB key inside a container in a dry
place.
• Pack the resistance unit in its original box. If
this box is not available, pack the unit, paying
particular attention to the flywheel. During
shipments, packs often undergo mistreatment
and very hard impacts, therefore inadequate
packing can result in permanent damage to the
roller. This type of damage is not covered by the
warranty. Pack the roller as though it had to be
dropped with box from a height of 1 metre.
Note: Before sending the roller or any other
component assistance, always firstly consult Elite
or the distributor.
is opened or tampered with.
• Since the feet are made from soft non-slip material,
during use they may leave rubber marks on the floor.
• During use of the RealAxiom Wireless with Ela-
stogel roller, slight wear of the roller is to be con-
sidered normal. Tests carried out at Elite show that
after continuous use for 20,000 km, roller wear is
around 0.1 mm, and as the total thickness is 11 mm,
far greater wear does not prevent correct operation
of the trainer. Claims due to improper or careless
use will not be acknowledged. Possible slight wear
of the rubber part comes within the norm.
• Use with narrow tyres or with non-optimum tyre pres-
sures can permanently damage the Elastogel roller.
• Pay attention to the pressure between tyre and
roller: tighten the plate adjustment screw three
complete turns from when the roller touches the
tyre. If the tyre still slips on the roller, tighten the
screw another turn and make the pressure on the
pedal more progressive. Training with the tyre slip-
ping will permanently damage the Elastogel roller
and the tyre.