Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
WARNING. NOTE. DO NOT CONNECT THE USB CABLE TO THE COMPUTER
Illustration 1 shows the diagram of the
RealTour B+. The parts in black are supplied
monitor
PC
USB Key
ASSEMBLING THE STAND
• Place the stand (Ref. A) on a flat surface.
• Remove the screws (Ref. S + V + X) in the
stand (Pic.2).
• Using the screw shown in Fig.2, fit the unit
support (Rif. F) on the respective frame (Fig. 3).
Use the correct tightening force, otherwise the
unit support will be prevented from turning.
UNIT INSTALLATION
• To place the resistance unit (Ref. D) on the
support (Ref. F), please use the M6x40 screws
(Ref. B) and the M6 washers (Ref. C) as shown
in picture 4.
ATTENTION: there are two pairs of holes in
the base of the support; use the various holes
according to the bicycle wheel:
1) for wheels ≥ 24" ÷ ≤ 26", front pair of holes
(Fig.5);
18
ASSEMBLING INSTRUCTIONS
BEFORE INSTALLING THE REAL SOFTWARE
SEMPLIFIED GENERAL DIAGRAM
Travel Block
in the RealTour B+ box, while the user must
provide the parts in grey.
cadence
sensor
resistance
unit
magnet
2) for wheels ≥ 28", rear pair of holes (Fig. 6).
• Depending on the wheel, tighten the M6
screws (Fig. 7 and Fig. 8).
• Use only the supplied spanner. Once resi-
stance unit and support come into contact,
rotate the screw up to ¼ of a turn (max 2Nm).
• For bicycles with wheels larger than 28" it is
necessary to operates on the frame, changing
the plugs of the front uprights with the oversi-
ze plugs provided (E). These differ for the
stand opening angle.
ATTENTION: this operation must be carried
out with the unit removed from the support.
• Remove the screws from both front uprights
(Fig.9 and Fig.10).
• Remove the plug, using a screwdriver if
necessary Fig. 11. Insert it inside the seat
specially created in the plug and prise,
pushing the screwdriver downward and the
plug upward.
• Repeat the same operation also for the
other plug.
• Fit the plugs for wheels larger than 28" (E),
1
Publicité
Table des Matières
Dépannage
