Name And List Of Components; Assembly; Use; Folding The Quick Motion - Elite Quick-Motion Mode D'emploi

FRONT ROLLER
UPPER KNOB
TRANSMISSION BELTS
CENTRAL ROLLER
CURSOR POSITIONS 1-2-3

ASSEMBLY

Your Quick-Motion roller should arrive fully as-
sembled, checked and ready for use.

USE

1) Twist the safety switch (Ref. L) to the open po-
sition "I" (Pic. 1) .
2) Unfold the hometrainer to its open position (Pic.
2).
3) Place the belts (Ref. C) in their 2 front and rear
housings, making sure the don't become jammed
between the plastic parts (Pic. 3 – Pic.4 – Pic. 5).
4) Before completely unfolding the Quick-Motion,
you must adjust the distance between rollers to
make it compatible with your bicycle's frame. The
adjusting process is conducted as follows:
• measure the distance from center to center
between the wheels of the bike being used on the
Quick Motion (Pic. 6). This distance is designated
as "X".
• The hometrainer comes set at a "Y" wheelbase
distance of 924mm (37 inches) between the whe-
els (Pic. 7) and can be adjusted for wheelbases up
to 1144mm (45 inches). If your wheelbase is over
924mm (37 inches), use the lower knob (Ref. H)
(Pic. 8) and extend the bar to the number closest
to dimension "X" according to the graded scale
(Pic. 9).
! CAUTION!
Do not unscrew the knob completely!
• Once the correct "X = Y" wheelbase is set, re-
tighten the lower knob (Ref. H) (Pic. 10).
5) To unfold your Quick-Motion completely, grab
the front handles with both hands and give a
strong push downwards (Pic. 11 and Pic. 12).

NAME AND LIST OF COMPONENTS

1 Rif. A
1 Rif. B
2 Rif. C
1 Rif. D
1 Rif. E
REAR ROLLER
FRONT COUNTER WHEELS
LOWER KNOB
OSCILLATING WHEELS
SAFETY KNOB
! CAUTION !
If the bicycle being used has a wheelbase grea-
ter than 1044mm, before using the product, the
hometrainer must be opened gradually (until
completely opened) to allow the belts to stretch
naturally.
6) Lock the unit by using the upper knob (Ref. B)
(Pic. 13).
7) The Quick-Motion is now ready for training ses-
sions!
!CAUTION!
For your own safety, set the hometrainer at 10-
15mm (0.4 - 0.6 inches) forward of the central axis
of the front wheel (Pic. 14). Should the front wheel
be positioned too far forward, it might fall out of
the hometrainer.
• The incorrect positioning of the bicycle on the
hometrainer might damage the hometrainer.

FOLDING THE QUICK MOTION

1) For ease of transport or to just reduce clutter
when not in use, we suggest folding the frame
(Pic. 10 and Pic. 9). Unlock the system by using
the upper knob (Ref. B) (Pic. 15). Grab the Quick-
Motion by the side of the front edges and fold the
hometrainer (Pic. 16 and Pic. 17).
EN
1 Rif. F
2 Rif. G
1 Rif. H
4 Rif. I
1 Rif. L
15