Removing The Cover Panel For The Electrics/Gas/Water Installation Compartment; Removing The Cover Panel On The Generator Compartment - Salvis VisionPro Série Notice De Montage

4.1.3 Removing the cover panel for the electrics/gas/water installation
compartment
4.1.4

Removing the cover panel on the generator compartment

Attached with plates at the top
40 / 72
Installing the connection between top and base units
Cover panel attached at the top
Hexagon screws M5x10, WAF
8 mm, art. no. 003743
Release four screws
Cover
. Remove the hexagon screws at the
bottom.
D Support the cover panel when removing
the last screw.
. Remove the cover panel.
Removing the air filter
. Unlock the filter cover by turning the knob
anticlockwise.
. Pull out the filter cover at the bottom by
about 3 cm and pull it down out of the
tabs.
D Support the air filter while removing the
filter cover.
. Remove the air filter from the filter cover.
Remove the cover
. Release four screws by approx. 2 - 3 cm.
D Do not remove completely.
D Screw M4x10, hexagon socket WAF 2.5
mm, art. no. 02221807
. Slide the cover upwards far enough until
the cover panel can be removed to the
front.
Assambly instruction Cooking station