Salvis VisionPro Série Notice De Montage page 37

Top unit
Base unit
Support plate
Installation module
Support
plate
Assambly instruction Cooking station
Installation, assembly at the installation site
Align top unit
Fixed with four screws
Attachment plate
Welding bolt M5
Pactan
Adhesive tape
Pactan
Worktop
M5
Connecting base and top units
- Open the operating panel, see page 17
chapter 4.1.1
. Align the top unit centrally to the base unit.
D The operating panel still has to close after
the side panels have been installed. Install
the side panels for checking and aligning
the top/base units (see page 25 chapter
6.).
. Screw together the base and top units.
- Hexagon screw M8x25, WAF 13 mm,
art. no. 011681
- Washer A8.4 (art. no. 001325)
- Washer A10.5, art. no. 735647 (larger
washer can be bent downwards – atta­
ching top unit to base unit).
Installing installation modules supplied
separately
Caution – crushing hazard when installing
the installation module!
Sample figure – deep fat fryer FSP:
. Attach adhesive tape (insulating tape) to
the support plate all around to prevent the
Pactan silicone from adhering to the sup­
port plate (facilitates removal when ne­
cessary).
. Degrease/clean the adhesive area.
. Apply an approx. 3-4 mm thick bead of
Pactan continuously along the support
plate.
- Adhesive kit Pactan 150 ml (TB 77),
with spatula, art. no. 888585
- Pactan cartridge 310 ml, art. no.
373060
. Insert the installation module.
. Attach the installation module with the
combination nut M5 (article no. 541397).
10
‐1
. Remove any excess Pactan adhesive.
37 / 72