Clearance Around The Air Conditioning System; Air Inlets / Outlets; Condensation Traps; Declaration Of Conformity - Truma Aventa comfort Mode D'emploi Et Instructions De Montage

Clearance around the air conditioning system

The clearance around the external unit must be 20 mm at
the front and 100 mm at the side. At least 30 mm of clearance
must be left at the rear. Truma recommends clearance of
200 mm so that the exhaust air can blow out freely.
Fig. 8
The clearance around the air distributor must allow the air to
blow out without obstructions. The side clearance must be at
least 40 mm. The pivoting range of flaps and doors must be
taken into consideration.
Fig. 9

Air inlets / outlets

Fig. 10

Condensation traps

The condensation is led away via the roof of the vehicle.
Fig. 11
Right reserved to make technical changes!

Declaration of conformity

1. Information about the manufacturer
Name: Truma Gerätetechnik GmbH & Co. KG
Address: Wernher-von-Braun-Str. 12, D-85640 Putzbrunn
2. Device identification
Type / model:
Aventa comfort air conditioning system
3. Complies with the requirements of the following
EC directives
3.1 Electromagnetic compatibility 2004/108/EC
3.2 Low voltage directive (2006/95/EC)
3.3 Radio interference suppression of motor vehicles 72/245/
EEC (with supplements), ECE Regulation R10 Revision 3
3.4 End-of-life vehicle directive 2000/53/EC
and bears the type approval number E24 10R-030696
and the CE symbol.
4. Basis of the proof of conformity
EN55014-1; EN61000-3-2; EN61000-3-3; EN62233:
EN55014-2; IEC / EN60335-1; IEC / EN60335-2-40;
2009/19/EC; DIN EN378-2;
5. Signatory details
Signature: p.p. Axel Schulz
Product Centre Manager Putzbrunn, 21.10.2013
19