Bradley Smoker BS611 Série Manuel Du Propriétaire page 7

4-Rack Digital Smoker (BTDS76P & BTDS76CE-EU)
6-Rack Digital Smokers (BTDS108P & BTDS108CE-EU)
For the 4 and 6-Rack Digital Smokers, please refer to the corresponding sections.
Refer to Part Numbers in External Components List, Internal Components List and Electrical
Original Bradley Smoker®
1. Remove smoker from box.
2. Take all packaged parts out of
smoker.
3. Remove all protective packaging
materials from parts.
Install Smoke Dial Generator:
• Attach Smoke Dial Generator (1)
to the Smoker Tower (2).
• Aim the Bisquettes Burner (F)
toward the tower opening.
• Align Smoke Dial Generator key
holes to smoker tower locating
supports (3).
• Secure the Smoke Dial Generator
• Insert the feeder tube (4) on top
of the smoke dial generator and
the desired number of Bradley
Flavor Bisquettes®.
• Plug the Short Power Cord (E -
not shown) from the Smoke Dial
Generator into the Smoker Tower.
Set Up Smoker Tower:
• Place Racks (C) onto side
supports.
• Place Drip Tray (B) "V" facing
down beneath the Racks on the
brass side pins.
Assembly Instructions
Connection Set Up
• Place the Rectangular Tray (J) on
the bottom of the Smoker.
• Fill the Drip Bowl (D) half full
of water and place in the center
of the Rectangular Tray to catch
burnt Bisquettes. During a long
smoking period, empty and
refill your water bowl
every 2 hours.
• Plug the Long Power Cord (A)
for the smoke generator into an
approved grounded electrical
outlet.
To Remove Smoke Dial Generator:
• Unplug Short Jumper Cord (E).
• Detach smoke dial generator
from the smoker tower by raising
the Smoke Dial Generator gently
upward and pull it outward.
All packaging should be discarded
as per the regulations in your area.
should not be used as a cover when
smoker is in use.
6
Handling of Packaging