Bradley Smoker BS611 Série Manuel Du Propriétaire page 21

(After mounting Generator on Side of Smoker)
TO ENSURE CONTINUED PROTECTION AGAINST RISK OF ELECTRICAL
SHOCK CONNECT TO PROPERLY GROUNDED OUTLET ONLY
DISCONNECT FROM POWER OUTLET BEFORE CLEANING OR SERVICING
This device complies with Industry Canada licence-exempt RRS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation
of the device.
ELECTRICAL CONNECTION SET UP
IN THIS ORDER
DO NOT IMMERSE / DO NOT EXPOSE TO RAIN
1. First plug sensor cable (1) into the
back of the generator (A) and smoker
(B).
2. Plug short jumper cord (2) into the
receptacles in the smoker (C) and
generator (D).
3. Plug the long power cord (3) into
the power receptacle in generator (E).
4. Lastly plug the long cord (3) into a
wall outlet (4). (Extension cords
should be for outdoor use and the
connection to the extension cord
should be dry and off the ground).
CAUTION
CAUTION
19