Bradley Smoker BS611 Série Manuel Du Propriétaire page 11

4-Rack Digital Smoker (BTDS76P & BTDS76CE-EU)
6-Rack Digital Smokers (BTDS108P & BTDS108CE-EU)
Refer to Part Numbers in External Components List, Internal Components List and Electrical
How to Assemble the
Bradley Digital Smoker®
1. Remove smoker from box.
2. Take all packaged parts out of
smoker.
3. Remove all protective packaging.
Install Digital Smoke Generator:
Attach Digital Smoke Generator (1)
•
to the Smoker Tower (2) by placing
the Bisquette Burner (E) through the
left side opening of the tower. Align
the generator keyholes to the two
supports (3) on the side and push
down to secure in position.
Insert the feeder tube (4) into
•
the top of the smoke generator.
desired number of Bradley Flavor
Bisquettes®.
Electrical Connection Set Up
Plug the Sensor Cable (1) into
•
the back of the Smoke Generator
Sensor Receptacle (A) and Smoker
•
Tower Sensor Receptacle (B).
Plug the Short Power Cord
•
(2) into the back of the Smoke
Generator Female Receptacle (D)
and then into the back of the
Smoker Tower Male Receptacle
Assembly Instructions
Connection Set Up
•
into the power receptacle (E).
Set Up Smoker Tower:
•
onto side supports.
•
down beneath the Racks on the
brass side pins and under pin (I).
•
on the bottom of the Smoker.
•
with water and place in the center
of Rectangular Tray (D) to catch
burnt Bisquettes. During a long
smoking period, the Drip Bowl
will require changing the water.
•
from the Smoke Generator into
an approved grounded electrical
outlet (4).
(see page 13)
13)
has had time to cool down. Unplug
Long Power Cord (3) from the wall
outlet (4) and from
the Smoke Generator (E). Detach
Sensor Cable (1) and Short Power
Cord (2) and then remove Smoke
Generator from the Smoker Tower
by raising it gently upward and
pulling it outward.
10
Plug the Long Power Cord (3)
Place Racks, either four or six (B)
Place Drip Tray (A) "V" facing
Place the Rectangular Tray (D)
Fill the Drip Bowl (C) half full
Plug the Long Power Cord (3)
To Remove Smoke Generator
Make sure the Smoke Generator
page 6
(see page