Safety System - Stiga VILLA 12 Mode D'emploi

EN
1 GENERAL
This symbol indicates WARNING.
Serious personal injury and/or damage
to property may result if the
instructions are not followed carefully.
You must read these instructions for use
and the accompanying pamphlet
"SAFETY INSTRUCTIONS"
carefully, before starting up the
machine.
1.1 SYMBOLS
The following symbols appear on the machine.
They are there to remind you of the care and
attention required during use and maintenance.
This is what the symbols mean:
Warning!
Read the instruction manual and the safety
manual before using the machine.
Warning!
Watch out for discarded objects. Keep
onlookers away.
Warning!
Always wear hearing protectors.
Warning!
This machine is not designed to be driven
on public roads.
Warning!
The machine must not be driven in any
direction on slopes with a gradient greater
than 10º.
Warning!
Risk of burn injuries. Do not touch the
silencer/catalytic converter.
1.2 REFERENCES
1.2.1 Figures
The figures in these instructions for use are
numbered 1, 2, 3, etc.
Components shown in the figures are marked A, B,
C, etc.
A reference to component C in figure 2 is written
as follows:
"See fig. 2:C." or simply "(2:C)"
1.2.2 Headings
The headings in these instructions for use are
numbered in accordance with the following
example:
"1.3.1 General safety check" is a subheading to
"1.3 Safety checks" and is included under this
heading.
When referring to headings, only the number of the
heading is normally specified. E.g. "See 1.3.1".
46
ENGLISH
2 DESCRIPTION
2.1 DRIVE
The machine has front-wheel drive.
Front-mounted implements are powered via drive
belts.
2.2 STEERING
The machine has rear-wheel steering. The rear-
wheel steering means that the machine can easily
turn around trees and other obstacles. Steering is
controlled via a wire or wire-chain.

2.3 SAFETY SYSTEM

The machine is equipped with an electrical safety
system. The safety system interrupts certain activ-
ities that can entail a danger of incorrect manoeu-
vres.
For example, the engine can only be started if the
clutch-parking brake pedal is depressed.
The operation of the safety system must
always be checked every time before
use.
2.4 CONTROLS
2.4.1 Implement lifter, mechanical (1:A)
To switch between working position and transport
position:
1. Depress the pedal fully.
2. Release the pedal slowly.
2.4.2 Service brake - Clutch - Parking
brake (1:B) (MAN)
A pedal that combines both service brake and
clutch. There are 3 positions:
NOTE! You must never regulate the operating
speed by slipping the clutch. Use a suitable gear
instead, so that the right speed is obtained.
1. Pedal released – forward
drive engaged. The machine will
move if a gear is engaged.
Service brake not activated.
2. Pedal depressed halfway –
forward drive disengaged, gear
shifting can be performed.
Service brake not activated.
3. Pedal fully depressed –
forward drive disengaged.
Service brake fully activated.