FIOR & GENTZ NEURO SWING H2O Notice D'utilisation page 18

Risk of Falling Due to Loosening of the Bearing Nut
Secure the screw of the joint case with the specified torque and the corresponding adhesive and make sure
that no sliding washers are damaged in the process.
Risk of Falling Due to Incorrectly Selected System Components
Use the Orthosis Configurator to select the system joint and individual system components in order to
avoid joint dysfunction.
Risk of Falling Due to Permanent Higher Load
If patient data has changed (e.g. due to weight gain, growth or increased activity), recalculate the expected
load on the system joint, plan the treatment again and, if necessary, produce a new orthosis. For this
purpose, use the Orthosis Configurator or contact Technical Support.
Risk of Falling Due to Improper Shoe/Wrong Shoe Pitch
Advise the patient to wear a shoe to which the orthosis is adjusted in order to avoid joint dysfunction.
Risk of Falling Due to Excessive Readjustment of the Spring Unit
Adjust the spring unit according to the information in these instructions for use. Do not make readjustments
of more than 10°. Use the laser markings on the system stirrup and the joint case to check the readjustment.
Damage to the Anatomical Joint Due to Incorrect Position of the Joint's Mechanical Pivot Point
Determine the joint's mechanical pivot points correctly in order to avoid a permanent incorrect load on the
anatomical joint. Please refer to the online tutorials on our website or contact Technical Support.
Jeopardising the Therapy Goal by Not Providing the Necessary Free Movement
Check if the system joint moves freely in order to avoid restrictions of the joint function. Use suitable
sliding washers according to the information in these instructions for use.
18
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING