TOOLCRAFT 1619737 Notice Originale page 53

When the log is supported on one end (Ú Fig. 19), cut 1/3 the diameter from the underside (underbuck). Then make
the finished cut by overbucking to meet the first cut.
Fig. 19
When the log is supported on both ends (Ú Fig. 20), cut 1/3 the diameter from the top (overbuck). Then make the
finished cut by underbucking the lower 2/3 to meet the first cut.
Fig. 20
When bucking on a slope always stand on the uphill side of the log (Ú Fig. 21). When "cutting through", to maintain
complete control release the cutting pressure near the end of the cut without relaxing your grip on the chain saw
handles. Do not let the chain contact the ground. After completing the cut, wait for the saw chain to stop before you
move the chain saw. Always stop the motor before moving from tree to tree.
2/3
1/3
1/3
2/3
53