17. Maintenance and Care
Regularly check the functional safety of your remote control and smooth running of the motor of the model plane. All
moving parts have to be easily movable but there should not be a clearance in the bearing.
Clean the exterior of the model plane and the remote control only with a soft, dry cloth or brush. Never use any ag-
gressive cleansing agents or chemical solvents, since this might damage the surfaces.
Important!
If you have to replace any damaged or worn parts, only use original replacement parts.
The spare parts list is located on our website www.conrad.com in the download section to the respective product.
Alternatively, you may also request the spare parts list on the phone. The contact information is included at the begin-
ning of these operating instructions, chapter „Introduction".
Propeller change
Proceed as follows to replace a damaged propeller:
• Secure the lower large gear wheel with your finger (see arrow in figure 15).
• Turn the propeller manually counter-clockwise (from the front) and screw the propeller from the shaft.
• Apply the included replacement propeller and tighten it clockwise (from the front).
50
Figure 15