Components And Assembly; Components And Standard Accessories Of The "Fitvib; Xcel" Vibration Device; Optional Accessories Of The "Fitvib E Xcel" Vibration Device - GymnaUniphy fitvib Excel Mode D'emploi

2. COMPONENTS AND ASSEMBLY

e

2.1 Components and standard accessories of the "fitvib

xcel" vibration device

Vibration plate with power cable
Soft mat
Manual switch
Handstraps, 2 pcs
Footstraps, 2 pcs
Assembly items, 1 bag
Manual
e
2.2 Optional accessories of the "fitvib xcel" vibration device:
Side cushion
All standard accessories (see above)

2.3 Description of the control units and accessory items

On the last page of this manual, you will find a fold-out diagram of the device with all accessory items
(Fig. 1). The numbers in the diagram and the text refer to the same items.
1 - Vibration plate
2 - Footstrap
3 - Foot switch (start/stop)
4 - Handle
5 - Handstrap
6 - Control unit / display
7 - "Start / stop" buttons
8 - "Intensity"button
9 - "Reduce Vibration Time" button
10 - "Reduce Frequency" button
11 - Display
12 - "Increase Frequency" button
13 - "Increase Vibration Time" button
14 - "Select Operating Mode" button
15 - Chip card slot
16 - Side cushion
17 - Soft mat
18 - Power cable
19 - Power switch
20 - Fitting for handstrap or footstrap
21 - Socket to connect manual switch
22 - Manual switch with start / stop function

2.4 Acceptance of delivery

Check whether the device has been damaged during transport and whether the accessory items are
complete and undamaged (see 2.1). Contact your supplier immediately in the event of damages and
incomplete delivery. Do not use the device when it has been damaged.

2.5 Power voltage

Your device has been manufactured for use at a power voltage of either 230 V, 50-60 Hz or 115 V,
50-60 Hz. Check the type plate for compatibility. Use of the device at an unsuitable voltage can cause
irreparable damage.

2.6 Removing the transport safety device and attaching the handle to the vibration plate (fig. 2)

e
Before you can start using the "fitvib xcel" vibration device, you must first remove the transport safety
device in the electronic unit (30),
Use the hexagonal turnscrew (32) to remove the four screws (34) at the bottom (33) of the electronic unit
(30). Then pull the sheet metal component (31) out of the electronic unit.
e
fitvib xcel User Manual, Version 01/2005 9