RAMSEY WINCH RPH 111,2 Traduction Des Instructions Originales page 15

14. Apply Permatex to threads of plug item #47. Thread plug into tapped hole in bottom of gear
housing end bearing item #11. Pour approx. 1.2 liters (2.50 pints) of SAE 80W-140 oil into end
bearing. Check oil level by removing oil plug noted below. Insert relief fitting item #41 and thread
reducer item #46 into end bearing at oil fill hole.
Install winch and connect pressure lines. Bleed pressure release section of brake by loosening
bleeder fitting on brake and allowing air to escape while slowly appling hydraulic system pres-
sure to the winch (refer to bleeder fitting in step 13). Apply at least 15,9 bar (230 PSI) pressure
to release brake and verify that brake releases, by observing that the winch drum rotates
15. Check proper operation of clutch by applying air pressure to clutch air cylinder to disengage
clutch. Verify that winch freespools. Re-engage clutch. A loud noise should be heard when clutch
engages. Winch drum should not freespool.
16. Operate winch forward and reverse to verify that drum rotates.
LEFT HAND MOUNTING
41
WINCH MOUNTING CONFIGURATION
46
11
OIL LEVEL PLUG
47
RIGHT HAND MOUNTING
12