Cleaning And Maintenance; Water Changes Color Or Becomes Cloudy; Replacing The Batteries (Fig. F); Troubleshooting - Tunturi FitRow 70 WTR Manuel De L'utilisateur

English
Race mode
- Press mode button to select "Race Mode" and
confirm by pressing "Enter".
- L9 will be displayed, use Up/ Down key to set
required "Race mode" level, and confirm with
"Enter".
Displayed "Time/ 500 is the PC time you need to
beat.
Mode Time/ 500
L1 8:00 min
L2 7:30 min
L3 7:00 min
L4 6:30 min
L5 6:00 min
L6 5:30 min
L7 5:00 min
L8 4:30 min
- Set desired training distance (± 500 mtr) and
confirm with "Enter"
- Press "Start/ Stop" button to start a 3 seconds
countdown prior to your training start.
NOTE
• Training will end, when computer (PC) or you
(User) has reached the end first.
• Console will display "User win" or "PC win"
when you or computer reaches the end first, and
stops training.
Mode Time/ 500
L9 4:00 min
L10 3:30 min
L11 3:00 min
L12 2:30 min
L13 2:00 min
L14 1:30 min
L15 1:00 min
2 0

Cleaning and maintenance

The equipment does not require special maintenance.
The equipment does not require recalibration when
it is assembled, used and serviced according to the
instructions.
WARNING
• Do not use solvents to clean the equipment.
• Clean the equipment with a soft, absorbent cloth
after each use.
• Regularly check that all screws and nuts
are tight.
• If necessary, lubricate the joints.
Water changes color or becomes
cloudy
Possible cause:
Rower is in direct sunlight or has not had water
treatment.
Solution:
- Change rower location to reduce direct exposure to
sunlight.
- Add water treatment or change tank water as
directed in the water treatment section of this
manual.

Replacing the batteries (fig. F)

The console is equipped with 2 AA batteries at the rear
of the console.
- Remove the cover.
- Remove the old batteries.
- Insert the new batteries. Make sure that batteries
match the (+) and (-) polarity markings.
- Mount the cover.

Troubleshooting

Despite continuous quality control, defects and
malfunctions caused by individual components may
occur in the equipment. In most cases it's unnecessary
to take the whole device in for repair, as it's usually
sufficient to replace the defective part.
If the equipment does not function properly during use,
contact your Tunturi dealer immediately. Always give
the model and serial number of your equipment. Please
state also the nature of the problem, conditions of use