Incompatible Vehicle Seat Belts - Britax Frontier XT SICT Guide D'utilisation

Vehicle Compatibility
Lap.Belt
IMPORTANT: A Lap belt may only be used to install the child seat
in harness mode and should never be used to secure your child in
booster mode.
5..
ALR.(Automatic.Locking.Retractor)
Has a latch plate that is
a
sewn into the webbing.
Has a retractor that stops the
b
belt from being pulled out
again once the belt webbing
has been pulled out at least
61 cm (24 in.).
Tightens by feeding the
c
belt webbing back into the
retractor.
6..
Locking.Latch.Plate
Has a latch plate that
a
does not allow the belt to
become loose after it is
buckled.
Tightens by pulling on the
b
belt webbing.
10

Incompatible Vehicle Seat Belts

compatible with this child seat. If any of the belt types listed below are
in the chosen seating position, choose another vehicle seating position
or check your vehicle owner's manual for information on installing a car
seat in your vehicle.
Latch
Plate
1
4
Vehicle Buckle Positions
seat belt buckle can adversely affect the
Latch
stability of the child seat.
Plate
If the buckle lies near the incorrect position ( ) when
the vehicle seat belt is tightened, try fitting the child
Adjuster
seat in another seating position in the vehicle. If it is
not possible to achieve the correct position ( ) for
the buckle, then another seating position MUST be
used.
WARNING!
The following types of vehicle seat belts are NOT
2
Lap-shoulder belts Motorized,
with top or bottom automatic vehicle
anchor points on seat belts.
the vehicle door.
5
Inflatable lap- Lap belts forward
shoulder belts. of the vehicle seat
bight.
The position of the vehicle
WARNING!
Vehicle Compatibility
3
Lap-shoulder
belts that have a
separate retractor
each for the
lap section and
shoulder section.
6
Lap belts with a
sewn-in latch plate
that have a retractor
that locks only in case
of a sudden stop.
11