Installing.the.child.seat:.harness.mode; Checklist - Britax Frontier XT SICT Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installing the Child Seat: Harness Mode
LUAS – Short Path
Before you begin:
9 Check that your vehicle has LUAS anchors.
* Check your vehicle owner's manual for the vehicle's LUAS
anchor limits.
9 Check that your vehicle has a top tether anchor.
* The Versa-Tether MUST be used at all times with this child
restraint. Using the tether will improve the stability of your child
seat and reduce the risk of injury. Check your vehicle owner's
manual for tether anchor locations.
9 Remove the Versa-Tether
place it over the child seat back to keep it from becoming
pinned between the child seat and vehicle seat during
installation.
Versa-Tether
®
(Top
Anchorage
Strap)
Short.LUAS.belt.path.installation
22
hook from the storage clip and
®
Installing the Child Seat: Harness Mode
Locate the LUAS anchors in
1
your vehicle.
* Ensure harness height is
adjusted to fit your child.
Rotate the positioning block to
2
the front and place the child
seat on the vehicle seat.
Verify that the lower connector
3
strap is not twisted and firmly
press the lower connectors
onto their adjacent LUAS
anchors to attach.
Push the child seat into the
4
vehicle seat and pull the end
of the lower connector strap
through.the.belt.slot.to
secure.
* The child seat is secure when it
cannot be moved front-to-back
or side-to-side more than 2.5
cm (1 in.) at the belt path. If the
child seat is not secure, repeat
the installation procedure or
use a different seating location.
Firmly press the Versa-Tether
5
hook to the vehicle tether
anchor to attach. Remove all
slack from the tether webbing.
Use the elastic strap to contain
6
extra webbing.

Checklist

9 Check that positioning block is rotated to the front.
9 Check all connections and verify that child seat is secure.
* The child seat is secure when it cannot be moved front-to-
back or side-to-side more than 2.5 cm (1 in.) at the belt path.
If the child seat is not secure, repeat the installation procedure
or use a different seating location.
9 Ensure any excess Versa-Tether
band. Always ensure any excess webbing is contained within
your vehicle.
1
OR
®
OR
webbing is stored in elastic
®
2
23

Publicité

Chapitres

Table des Matières
loading

Table des Matières