Care and Maintenance
Cleaning the Cover
• HAND WASH the cover using cold water and mild soap.
• LINE DRY to prevent the cover from shrinking.
• DO NOT:
* Bleach
* Machine wash
* Machine dry
* Iron
Cleaning the Harness
• SPONGE CLEAN the harness using warm water and mild soap.
• TOWEL DRY
• DO NOT:
* Disassemble the harness
* Bleach
* Machine wash
* Machine dry
* Iron
Cleaning the Shell
• SPONGE CLEAN the shell using warm water and mild soap.
• TOWEL DRY
• DO NOT use abrasive cleaners
Cleaning the Side Impact Cushions
• SPONGE CLEAN the cushion using warm water and mild soap.
• TOWEL DRY
• DO NOT use abrasive cleaners
WARNING:
Prevent the Side Impact Cushions from
being punctured. Puncture damage will cause the cushions not
to perform as intended.
Replacing the Cover
Fit the cover around the head
1
restraint.
* Be careful not to damage the
energy-absorbing foam.
Pull the cover fabric tight and
2
slide it between the child
seat shell and Side Impact
Cushion.
44
Fit the bottom of the cover
3
over the lower part of the child
seat shell, then pull the elastic
loops over the hook on the
bottom of the child seat shell.
Push the cover under the
4
lower belt guides.
Pull the head restraint cover
5
over the head restraint shell,
and reattach the elastic bands.
* Be careful not to damage the
energy-absorbing foam.
Move the harness adjuster to
6
the highest position (a), then
move the head restraint to the
lowest position (b).
* Ensure that harness slots in
the cover, head restraint and
harness adjuster are aligned.
Replace the screw to lock the
7
head restraint adjuster.
Pull the buckle through the
8
slot in the cover.
* Ensure that the buckle is
through the correct cover
slot for the buckle position.
2
Care and Maintenance
45